Single Bit Wireless Data Transmission
INTRO
This Article's about Transmitting Single bit Data from one end to another.
We're using a 433 MHz Channel for the Data Transmission.
For Multiple Channels we use an Encoder-Decoder Circuit.
For Easier Understanding Watch the Video.
COMPONENTS REQUIRED
Power Supply
5 V DC for each Circuit.
I used Raspberry and Arduino for Power Supply
Transmitter
433 MHz.
Single bit Data Transmitter.
Receiver
433 MHz.
Single bit Data Receptor.
Encoder
Used to convert single bit Data into Multiple Bits.
Decoder
Used to convert Multiple bits of Data into single Bit.
Bread Board
Jumper Wires
Male - Male
Male - Female
Female - Male
Push Type Switches
1D array switches.
Circuit Connections
Transmitter
Receiver
Connect the Transmitter and the Receiver to the Encoder and Decoder as shown in the Circuit Diagram below.
Decoder
Encoder
OUTPUT
Power up the Circuit and Separate the Circuits with a distance check for it to work.
Make sure you watch this Video:
For further Clarifications contact me :
mail : voxton95@gmail.com
Comments
Post a Comment